3 Series E36 325tds (M51) TOUR
51 14 110
Removing and installing/replacing model
designation (emblem) at rear (touring)
The model sign is glued and cannot be reused after
removal.
The model sign must be installed at room temperature.
Coat nylon string or thread with tenside (e.g. dish
detergent), cut through adhesive layer and remove with
washing benzene.
At paint baking temperatures exceeding 80
°
C, the model
designation must be removed.
touring:
Apply adhesive tape up to upper edge "A" and mark dimensions as per table.
Dimension in mm
touring 316 i ... 328 i:
A = 33.5, B = 608 (from center of BMW emblem), C = 16
touring 318 tds and 325 tds:
A = 33.5, B = 608 (from center of BMW emblem), D = 20
RA Removing and installing/replacing model designation (emblem) at rear (touring)
BMW AG - TIS
09.02.2013 02:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
