3 Series E36 328i (M52) COUPE
Unfasten oil pan screws at transmission and engine ends.
Lower oil pan and pull forwards to remove.
Installation:
Sealing faces clean and free of seal debris.
Apply Drei Bond 1209 sealing compound to area around joint
(refer to BMW Parts Service): approx. 3 mm wide and 2 mm
high.
Installation:
1.
Replace gasket
2.
Install oil sump.
3.
Insert all oil sump screws.
4.
Insert screws in transmission end without preload at this
stage.
5.
Tighten down screws in engine end.
6.
Tighten down screws in transmission end.
RA Removing and installing oil sump (M52 / S52 / M52TU / M54)
BMW AG - TIS
09.02.2013 11:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
