3 Series E36 328i (M52) COUPE
34 11 000
Removing and installing/replacing brake
linings on both front disk brakes
Note:
After completing the tasks, press brake pedal several times
to the floor so that brake linings contact brake disks.
When installing new brake linings on the front axle and
simultaneously replacing the brake linings on the rear axle,
check the brake-fluid level and top up to the "MAX" marking
if necessary.
Remove wheels.
Refer to 36 10 300
Lift out retaining spring (1).
Left:
Disconnect plug connection for brake lining wear sensor.
If necessary, replace brake lining wear sensor.
Remove plastic plugs (2).
Lift brake hose out of bracket.
Unfasten guide screws (1) and lift out brake caliper towards rear
of vehicle.
Installation:
Only clean guide screws; do not grease.
Check threads.
Replace all guide screws which are not in perfect condition.
Tightening torque, refer to Technical Data 34 11 3AZ
RA Removing and installing/replacing brake linings on both front disk brakes
BMW AG - TIS
09.02.2013 19:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -