3 Series E36 328i (M52) COUPE
61 35 ...
Troubleshooting power windows
Fault
Test procedure - specified value
Remedy
Test requirements
a)
Battery charged
b)
Fuses OK
c)
Door wiring harness
disconnected from power-
window drive
d)
Testing on door wiring harness
Window cannot be fully raised
a)
Striker closed
3-pin connector, pin 3 to vehicle
earth, specified value: 0 W
b)
Rotary tumbler opened or in
preliminary detent position,
nominal value
Ω
a)
If the specified value cannot be
maintained, open and close the
striker. If the specified value is
not reached, check plug-in
connection and switches at
striker and locking pawl.
b)
If nominal value is not achieved,
check plug connection and
switch on the rotary lock and
locking detent.
Replace striker switch and
locking pawl switch.
Raising window using comfort relay
does not work
a)
Terminal R switched on, or door
opened once after terminal R
switched off.
6-pin connector, pin 3 to pin 1,
specified value: approx. 8 V
b)
Terminal R switched off, door
shut, door opened and shut
again
6-pin connector, pin 3 to pin 1,
specificied value <1 V
a)
If the specified value is not
reached, check comfort relay,
wiring and central-locking
module
b)
If the specified value is not
reached, check comfort relay,
wiring and central-locking
module
Fault
Test procedure - specified value
Remedy
Lowering, raising, tip operation faulty 6-pin connector:
Pin 3 to vehicle earth, specified
value: approx. 12 V
Pin 6 to vehicle earth, specified
value: 0 V
Pin 2 to Pin 3, tipping, specified
value: approx. 12 V
Pin 3 to Pin 4, raising, specified
value: approx. 12 V
RA Troubleshooting power windows
BMW AG - TIS
10.02.2013 00:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -