3 Series E36 M3 (S50) CONVER
Turn crankshaft further in direction of rotation until last two bolts of
sprocket on VANOS gearbox are accessible.
Tighten these two screws to final torque of 10 Nm.
Remove special tool 11 3 490 between VANOS adjustment
unit and face of timing case.
Caution!
VANOS radial piston pump drive could fall into engine. For
this reason, drive must be held in position with a finger while
pulling off VANOS control unit.
Pull off VANOS control unit parallel to timing case far enough that
O-rings are accessible.
Clean and degrease sealing surfaces between end cover and
timing case.
Apply thin and uniform coat of 3 Bond 1209 sealing compound,
refer to BMW Parts Service.
Pay attention to dowel pins (1).
RA Replacing all camshafts (S50 B30)
BMW AG - TIS
09.02.2013 20:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 22 -