3 Series E36 M3 (S50) CONVER
Preload exhaust camshaft by rotating eccentric shaft.
Align bearing cover by hand until bearing cover and timing case
are located over hollow dowels.
Fit nuts to bearing cover of exhaust camshaft and tighten down.
Tightening torque,
refer to Technical Data 11 31 1AZ .
Untighten and remove special tool.
Install inlet camshaft together with VANOS transmission and
position timing chain so that cams of cylinder 1 point horizontally
inwards.
Important!
Note direction of installation and installation sequence. The
first bearing cover is marked with E and the rest are marked
from E2 to E7.
Check dowel sleeves.
Fit bearing covers.
Important!
If incorrectly fitted, i.e. without fixture, there is a risk of
preliminary damage or failure of camshaft.
Fit special tool 11 3 400 to depress the intake camshaft and
screw into spark plug threads of cylinders 2 and 5.
Tightening torque,
refer to Technical Data 12 12 1AZ .
RA Replacing all camshafts (S50 B30)
BMW AG - TIS
09.02.2013 20:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 12 -
