3 Series E36 M3 (S50) CONVER
Repeat procedure until sensor pin on chain wheel of VANOS
transmission aligns with marking on end cover.
Remove end cover (VANOS bridge) once again.
Align bearing cover by hand until bearing cover and timing case
are located over hollow dowels.
Fit bearing cover nuts on intake camshaft and tighten down.
Tightening torque,
refer to Technical Data 11 31 1AZ .
Untighten and remove special tool.
Fit open-end wrench on hex of exhaust camshaft.
RA Replacing all camshafts (S50 B30)
BMW AG - TIS
09.02.2013 20:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 15 -
