3 Series E36 M3 (S50) CONVER
Unfasten and disconnect cable connector (1) on Lambda oxygen
sensor bracket. Unfasten cable from bracket on transmission
cross member.
Loosen nut (1).
Pull retaining clip (2) off and remove cable (3) from bracket (4).
Installation:
Adjust cable,
refer to 25 16 ... .
Pull off retaining clip (1) and cable (2) from bracket (3).
Unfasten screws and remove transverse tube (1).
Installation:
Tightening Torque,
refer to Technical Data 41 11 1AZ.
RA Removing and installing transmission (S6S 420G SMG)
BMW AG - TIS
09.02.2013 22:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
