3 Series E36 M3 (S50) CONVER
34 00 009
Checking brakes on test stand
Note:
1.
Check tires for damage
2.
Check tire treads
3.
Check tire pressures
In the case of vehicles with ASC+T or DSC, the system must be
deactivated with the switch. The ASC+T / DSC indicator lamp in
the instrument cluster must light up!
The brakes must be at normal operating temperature. For this
purpose, gently warm up the brake disks/drums while dry by
braking the vehicle several times.
Caution!
You should only use brake dynamometers whose test speed
is
≤
5 km/h.
You must follow without fail the guidelines contained in the
operating instructions of the relevant test stand manufacturer.
Failure to do so may result in damage to the vehicle and the
system and also personal injury.
The maximum test duration for four-wheel drive vehicles is 3
minutes per axle! If it has to be repeated, it will be necessary
in the meantime to the drive the vehicle a distance of at least
1 km in order to achieve sufficient lubrication of the transfer
case.
RA Checking brakes on test stand
BMW AG - TIS
10.02.2013 01:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
