3 Series E36 M3 (S50) SAL
Check whether bevel splines of splined shaft (1) are precisely
aligned "tooth to tooth gap" with splined hub (2).
Special tool 11 3 490 must be used to install VANOS control
unit in order to be able to adjust control diagram.
Hold special tool 11 3 490 between VANOS control unit and
face of timing case.
Push in VANOS control unit as far as timing case.
Note:
Splined sleeve will be turned counterclockwise while pushing
bevel splines (1) into splined sleeve (2).
If bevel splines (1) cannot be pushed into splined hub (2),
splined shaft and VANOS control unit must be pulled off far
enough for it to be possible to turn splined shaft.
RA Replacing all camshafts (S50 B30)
BMW AG - TIS
09.02.2013 20:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 19 -