3 Series E36 M3 (S50) SAL
Slide on VANOS adjustment unit until sealing rings are still just
accessible.
Align radial piston pump on exhaust end with driver on splined
hub.
Clean and degrease sealing faces between end cover (VANOS
bridge) and timing case.
Apply thin, uniform coat of Drei Bond 1209 sealing agent (refer
to BMW Parts Service).
Pay attention to dowel pins (1).
Caution!
The radial piston pump is no longer accessible after fitting the
end cover (VANOS bridge). Check position of radial piston
pump to driver on splined hub, realign if necessary.
Fit end cover (VANOS bridge) to timing case and tighten down.
RA Removing and installing, sealing/replacing VANOS adjustment unit (S50 B32)
BMW AG - TIS
09.02.2013 21:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -