3 Series E36 M3 (S50) SAL
Installation:
Note dowel sleeves (1 ... 2) and replace if necessary.
Ensure correct position of cover plate.
Installation:
Remove and clean release unit and release lever and grease
appropriate points,
refer to 21 51 500.
Installation:
Check lubrication of transmission input shaft for sticky
consistency. If the grease is sticky, the clutch disk must be
replaced,
refer to 21 21 500.
Check clutch disk for friction rust in taper splines and replace
if necessary,
refer to 21 21 500.
Mechanically remove old grease and lining abrasion from the
taper splines of the clutch disk (with a cloth).
Clean taper grooves and guide pins on transmission input
shaft and apply a thin coat of grease with a brush.
Grease,
refer to BMW Service Operating Fluids.
RA Removing and installing transmission (S6S 420G SMG)
BMW AG - TIS
09.02.2013 23:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -
