3 Series E36 M3 (S52) COUPE
Installation
Installation of cylinder head is described separately from removal.
Clean sealing faces of cylinder head and engine block; if
necessary, remove traces of sealing compound with hardwood
spatula. Ensure that no gasket debris drops into the oil and
coolant ducts.
Check that dowel sleeves are undamaged and correctly located.
Apply permanently elastic sealing compound Drei Bond 1209
(refer to BMW Parts Service) to joints to timing case cover.
Fit new cylinder head seal.
M52
A 0.3 mm thick cylinder head gasket is available for machined
(milled) cylinder heads on the M52.
S52
Caution!
The milled surface of the cylinder head must not be machined
on the S52.
Note:
Check that all washers are in place.
RA Removing and installing/sealing cylinder head (M52 / S52)
BMW AG - TIS
10.02.2013 02:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -