3 Series E36 M3 (S52) COUPE
32 13 503
Dismantling and reassembling power steering
gear
- Power steering gear removed -
- Tie rods removed -
Caution!
When working on steering gear, always work carefully in clean
conditions.
All use of force prohibited during assembly and disassembly.
This can otherwise give rise to damage and culminate in
failure of the steering unit.
Remove leakage oil line.
Remove pressure lines and remove O-rings from threaded bores
or from lines.
1.
Mark position of adjusting screw (1) relative to case with
peening marks.
2.
Determine installation depth of adjusting screw (1) in case
with a depth gauge and note down the result.
3.
Loosen adjusting screw (1).
4.
Remove spring (2), O-ring (3) and pressure piece (4).
RA Dismantling and reassembling power steering gear
BMW AG - TIS
10.02.2013 05:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -