3 Series E36 M3 (S52) SAL
Replace catch pin (8) and pressure spring (9).
Caution!
Note installation position of catch pin (8) (roller horizontal).
Install sealing cap (1) with special tool 23 2 350 in bore bore (2).
Push sealing cap (1) inwards as far as possible.
Install retaining ring (3) and press in with special tool 23 2 350
up to groove.
Check for correct seating of retaining ring (visual inspection).
Install reverse gear switch.
Install spacer (4).
Caution!
To prevent damage to drive shaft, attach special tool
23 2 380 to drive shaft while installing retaining ring (3).
Slide retaining ring (3) over special tool 23 2 380 and install in
groove.
Retaining ring must be seated without play in groove.
Replace retaining ring with a matching retaining ring. Retaining
rings are available in various thicknesses.
Sizes: 2.2 ... 2.6 mm
RA Removing and installing complete drive and output shafts (S5D 260Z / 310Z / 320Z
BMW AG - TIS
10.02.2013 06:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 17 -