3 Series E36 M3 (S52) SAL
Heat housing in area of ball bearing to approx. 80
°
C (hot-air
blower).
Install ball bearing (2), if necessary drive in with special tool
23 1 470 until firmly seated.
Install retaining plates (1).
Install screws with screw retaining compound, refer to BMW Parts
Service, and tighten down.
Tightening torque, 23 11 17AZ.
Countershaft:
Install special tool23 1 280 in bearing shell (1) for roller bearing.
Fit special tool 33 4 020 .
Screw on special tool 23 1 300 .
Withdraw bearing shell.
RA Replacing bearings on all transmission shafts (S5D 260Z / 310Z / 320Z)
BMW AG - TIS
10.02.2013 06:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -