3 Series E36 M3 (S52) SAL
Fit 3rd/4th gear sliding sleeve with stepped side (3) facing
upwards.
The three set-back or opened teeth must point to the springs.
Tilt thrust pieces (1) individually as far out of sliding sleeve until
balls (3) can be placed on pressure springs.
Press balls (3) inwards. Simultaneously press thrust pieces into
sliding sleeve.
Insert 4th gear synchronizer ring (4) in recesses in guide sleeve.
Pull sliding sleeve uniformly upwards up to lock (neutral setting).
Fit needle bearing and 4th gear wheel.
Caution!
The needle bearing has been selected by the manufacturer in
accordance with a specific tolerance and is green in color.
Do not mix up with other needle bearings.
RA Disassembling and assembling all synchronizing mechanisms (S5D 260Z / 310Z / 320
BMW AG - TIS
10.02.2013 07:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 11 -