3 Series E36 M3 (S52) SAL
26 11 090
Removing and installing or replacing center
mount of propeller shaft
Remove propeller shaft,
refer to 26 11 000.
Completely fill center bore with viscous grease.
Drive special tool 11 1 130 into center bore with a plastic
hammer.
The center mount is forced out by applying pressure to grease fill
(1).
If necessary, top up grease repeatedly.
Note:
To drive out the mount, you can also fill the centering bore
with water instead of grease.
Remove grease or water from mount bore.
Drive in center mount (1) with special tools 00 5 500 and
11 2 030 up to protrusion (A).
Note:
Apply Molykote Longterm 2 grease to center mount (1),
refer to BMW Parts Service.
Lubricant volume: approx. 2 g.
Installation:
Overlap A = 4.5
+0.2
mm
RA Removing and installing or replacing center mount of propeller shaft
BMW AG - TIS
10.02.2013 07:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -