3 Series E36 M3 (S52) SAL
31 12 046
Replacing bracket for control arm
If necessary, remove heat baffle plate and reinforcement cross
from front axle carrier.
Punch-mark centre of control arm.
Unfasten screws.
Installation:
Use washers.
Tightening Torque,
refer to Technical Data 31 12 7AZ
Determine dimension (A) and note or mark the position of the
rubber mount on the transverse link.
The rubber mount must be pressed onto the transverse link up to
this dimension or this marking.
Composite parts of special tool 00 7 500.
RA Replacing bracket for control arm
BMW AG - TIS
10.02.2013 08:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -