3 Series E36 M3 (S52) SAL
Press-fit new taper roller bearing to new final drive case with
limited-slip differential cold using special tool 33 1 003.
Caution!
Only use same make bearings for both bearings.
Note make - this information is required later to determine the
friction torque.
Lift shaft seals out of both bearing caps.
Press out outer bearing race with special tool 33 1 350
(extractor fixture) and special tool 33 1 351 (extractor star tool).
Caution!
Special tool must engage in the bearing outer race.
Installation:
Press-fit new bearing outer races with special tool 33 1 365
(pressure plate).
RA Replacing complete locking differential (Type M) - final drive removed -
BMW AG - TIS
10.02.2013 09:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -