3 Series E36 M3 (S52) SAL
Install compression ring (9) and differential side gear (10) by
twisting into the guide and/or spline of the inner disc.
Installing differential gears with shafts (11), second differential
side gear (10) and compression ring (9).
Installing molybdenum-coated inner disc (8) and outer disc (7).
Insert diaphragm spring (6) with inside curved surface facing
differential shaft (down).
Install thrust washer (2) with oil packet facing cover, plate spring
(3) with inner bulge facing outwards and lug disc (4) with smooth
side facing plate spring and lug in groove of housing cover with
grease in housing cover.
Fit housing cover with washers (do not allow lug disc to slide out
of groove).
Install screws with Loctite No. 270 and tighten down cover evenly.
Installation:
For tightening torque, refer to Technical Data
RA Dismantling and reassembling limited slip differential (Type M) - rear axle remo
BMW AG - TIS
10.02.2013 09:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -