3 Series E36 M3 (S52) SAL
34 51 525
Removing and installing or replacing
ABS/ASC+T hydraulic control unit
Note:
Read and comply with General Information.
Important!
After completing work:
Check function of hydraulic control unit.
(Refer to BMW Diagnosis System)
Installation:
Bleed brake system.
Switch off ignition.
Disconnect battery negative lead.
Remove air-mass flow sensor with air cleaner housing,
Note:
The servomotor must be removed in cars with cruise control.
Draw the brake fluid out of the expansion tank. with a suction
bottle reserved for exclusive use with brake fluid.
RA Removing and installing or replacing ABS/ASC+T hydraulic control unit
BMW AG - TIS
10.02.2013 10:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -