3 Series E36 M3 (S52) SAL
Unlock and pull off central connector.
Note:
Keep brake fluid out of cable connector.
Unscrew brake pipe (1).
Installation:
Marking on master brake cylinder
V Front axle
H Rear axle
Unfasten brake pipes (2 ... 7) at hydraulic control unit.
Important!
Do not mix up brake pipes (mark if necessary).
Installation:
Pipe connections
1.
Brake master cylinder. H (rear axle)
2.
Front right
3.
Front left
4.
Rear right
5.
Rear left
6.
Brake master cylinder. V (front axle)
7.
Pressure accumulator
Tightening torque 34 32 1AZ.
RA Removing and installing or replacing ABS/ASC+T hydraulic control unit
BMW AG - TIS
10.02.2013 10:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -