3 Series E36 M3 (S52) SAL
34 52 515
Removing and installing/replacing control
unit for ABS/ASC+T
Before starting work, read out fault memory of ABS/ASC+T control
unit and print out diagnostic record.
Remove and install or replace ABS/ASC+T hydraulic unit.
To remove the ABS/ASC+T unit, seal the line connections with the
plugs provided in the repair kit. This prevents brake fluid from
being discharged from the hydraulic unit, which in turn makes it
easier to bleed the brake system later.
Release screws (1) and carefully detach control unit (2) from
hydraulic unit (3).
Installation:
Replace micro-encapsulated screws.
Observe tightening torque,
refer to 34 51 1AZ.
RA Removing and installing/replacing control unit for ABS/ASC+T
BMW AG - TIS
10.02.2013 10:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -