3 Series E36 M roadst (S54) ROADST
Screw in all remaining screws (1) on left/right sides and tighten
down.
Note:
The operation for "Installing tackstrip " ends here.
Fine adjustment of convertible top:
Lock down convertible top.
The convertible top must close flush with front of windshield (up to
2 mm lower than the windshield). For correction, where necessary,
adjust the locking hooks. Locking hook operates in two directions,
longitudinally and downwards, identical to angle of centering pin.
If the convertible top does not fit in longitudinal direction, change
the number of shims (4) in longitudinal direction.
If necessary, open convertible top.
Loosen screw (1) and nut (2) on left/right of main bearing and use
appropriate shims (4) to correct any deviation.
Tighten down left/right nuts (2) then loosen slightly again.
Tighten down left/right screw (1).
Tighten left/right nut (2).
RA Removing and installing complete convertible top (Z3 Roadster, M Roadster)
BMW AG - TIS
10.02.2013 05:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -