3 Series E36 Z3 (M54) ROADST
36 13
Subsequent installation of wheel-bolt lock
Loosen wheel bolts.
Lift car until wheel can be turned.
Loosen wheel bolts enough for it to be easy to move wheel on
wheel hub.
Turn wheel so that valve is face down.
Remove upper wheel bolt and insert wheel-bolt lock.
Possible play in wheel centre and wheel weight could cause
imbalance.
This imbalance is reduced to a minimum by installing the
somewhat heavier wheel-bolt lock in the top wheel-bolt position.
Tighten wheel bolts crosswise and by hand in this position (wheel-
bolt lock at top, valve at bottom).
Lower car and tighten wheel bolts crosswise.
For tightening torque,
refer to Technical Data
Should a customer complain about wheel imbalance after
installation of wheel-bolt lock, wheels will have to be finish-
balanced.
RA Subsequent installation of wheel-bolt lock
BMW AG - TIS
11.02.2013 07:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
