3 Series E46 316i (M43TU) SAL
VS-24/Kretschmann
Baugruppe/Group: 65
65 13 02 (910)
weltweit ohne
Japan
all countries
except Japan
Datum/Date:
09/2002
Problems when installing navigation software
E38, E39, E46, E52, E53, E65, E66 with radio navigation (option 606) or navigation
system with on-board monitor (option 609)
Complaint:
The following problems may occur while the navigation software is being copied to the
navigation computer:
•
The message "CD defective" appears.
The software cannot be copied.
•
The message "Fault during programming" appears. The software cannot be copied.
•
The message "The system is restarting" appears. The software cannot be copied.
•
The installation process is aborted. The on-board monitor or the display in the MIR is
dark and the power LED in the navigation computer is off. The CD is not ejected - it
remains in the navigation computer even if the eject button is pressed.
These fault patterns can occur if the navigation software CD has signs of use or slight
scratches. An exchange of the navigation computer is not permissible.
Affected vehicles:
E38, E39, E46, E52, E53, E65, E66 with radio navigation (option 606) or navigation system
with on-board monitor (option 609)
Manufacturing period:
E38, E39 from September 2000
E46 from June 2000
E52 from September 2000
E53 from December 2000
E65 from November 2001
E66 from March 2002
Procedure:
If the navigation software CD is ejected automatically or when the eject button is pressed
(points 1 - 3):
•
Insert a new, unused CD and restart the installation process. Do not use the CD on
which the fault occurred any longer.
If the navigation software CD is still in the computer (point 4):
•
Remove the navigation computer (please refer to Repair Instructions 65 90 510
"Removing and installing / replacing navigation computer with CD drive").
•
Unplug the voltage supply (blue connector).
•
Reconnect the voltage supply and immediately press the eject button repeatedly until
the CD in the drive is ejected.
•
Insert a new, unused software CD and restart the installation process (for procedure
for programming navigation computer, please refer to IDC 031/02-1). There may be a
delay of about 2-3 minutes before the screen for software installation appears and the
process starts. Do not use the CD on which the fault occurred any longer.
After the software has been successfully installed, reinstall the navigation computer.
Note:
These problems occur with scratched navigation software CDs. For this reason, it is
SI Problems when installing navigation software E38, E39, E46, E52, E53, E65, E66 w
BMW AG - TIS
19.01.2013 09:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
