3 Series E46 316i (M43TU) SAL
00 11 500
Checking/topping up fluid level in automatic
transmission (A5S 360R / 390R,
A4S 200R / 310R)
Caution!
Use only the approved transmission fluid in this automatic
transmission.
Failure to comply with this requirement will result in serious
damage to the automatic transmission!
Details of approved fluid type,
refer also to adhesive label on transmission fluid sump.
Move selector lever to park position "P".
The vehicle must be horizontal and secured against rolling off.
Note:
The illustration shows the transmission for vehicles with
gasoline/petrol engines. The filler plug for vehicles with diesel
engines and on the A4S 200R (GM4) transmission is located
at the front.
Connect BMW Diagnosis and Information System (DIS) or BMW
MoDiC to vehicle.
Release filler plug (1).
Top up automatic transmission fluid until overflowing.
Screw in filler plug (1) by hand.
Start engine and run at idle speed.
Actuate brake and shift through all gears at idle speed.
Open filler plug (1) again.
Increase temperature of transmission fluid to 30 ... 50
°
C.
Interrogate temperature of transmission fluid with MoDiC or DIS.
Top up automatic transmission fluid until overflowing.
Screw in filler plug (1).
Installation:
Check sealing ring on filler plug (1) for damage and if
necessary replace sealing ring and filler plug.
Tightening torque, 24 11 7AZ .
RA Checking/topping up fluid level in automatic transmission (A5S 360R / 390R, A4S
BMW AG - TIS
19.01.2013 10:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
