bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

ABOUT US
3 RA Removing And Installing, Sealing Or Replacing Bottom Timing Case (M43 _ M43TU)|Page 552 > < 3 RA Removing And Installing, Sealing Or Replacing Bottom Timing Case (M43 _ M43TU)

3 Series E46 316i (M43TU) SAL

Page 2
background image

If necessary, remove oil pump and control valve,

refer to 11 41 000.

If necessary, remove main flow oil filter,

refer to 11 42 020.

If necessary, remove water pump,

refer to 11 51 000.

Installation

Installation and removal are described separately.

Clean and remove grease from sealing surfaces of crankcase.

Make sure that sleeves are correctly seated.

Replace seal.

Clean groove for rubber profile seal and sealing surfaces on gear
case of remains of seal.

Apply Drei Bond 1209 sealing compound thinly and evenly to
the groove ends, refer to BMW Parts Service.

Seat new rubber seal in groove.

RA  Removing and installing, sealing or replacing bottom timing case (M43 / M43TU)

BMW AG - TIS

19.01.2013  10:36

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 2 -

3 RA Removing And Installing, Sealing Or Replacing Bottom Timing Case (M43 _ M43TU)|Page 552 > < 3 RA Removing And Installing, Sealing Or Replacing Bottom Timing Case (M43 _ M43TU)