3 Series E46 316i (M43TU) SAL
21 52 510
Removing and installing or replacing clutch
slave cylinder
Special tools required:
•
13 3 010
Note:
After completing work bleed clutch hydraulic system.
Important!
From 08.06 a plastic clutch slave cylinder is installed in the
E81, E87 and E9X.
Important notes on installation are described in this work step.
Seal supply hose to clutch master cylinder with special tool
13 3 010 .
Note:
Illustration shows E46.
Remove transmission underbody protection if necessary.
Release union screw (1) on hydraulic line.
Release nut (2) and remove hydraulic line (3) with bracket.
Installation:
Tightening torque 21 52 1AZ
.
Note:
Illustration similar.
Version with throttle valve, tightening torque 21 52 12AZ
.
RA Removing and installing or replacing clutch slave cylinder
BMW AG - TIS
19.01.2013 11:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
