3 Series E46 316i (M43TU) SAL
Release screws and remove exhaust bracket (1).
Support transmission with a workshop hoist.
Release screws and remove cross-member (1).
Tightening torque, 23 71 1AZ/2AZ.
Release screws.
Tightening torque, 26 11 1AZ.
Installation:
Replace self-locking nuts.
Grip propeller shaft and release nuts.
Tightening torque, 26 11 6AZ.
Bend propeller shaft downwards at center bearing.
Detach propeller shaft from transmission output flange and tie
back to side on vehicle underbody.
RA Removing and installing transmission (S5D 200G, M43TU)
BMW AG - TIS
19.01.2013 11:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
