3 Series E46 316i (M43TU) SAL
Caution!
Slowly relieve tension on clutch slave cylinder during removal
as otherwise air will be drawn in through sealing sleeve.
Release nuts and remove clutch slave cylinder. Pressure line
remains connected.
Tightening torque, 21 52 5AZ.
Detach locking clamp.
Pull shift rod (1) out of shift rod joint (2) and remove washers (3).
Installation:
Grease shift rod pin (4).
Grease,
refer to BMW Service Operating Fluids.
Large contact surface of disks (3) must rest on shift rod joint
(2).
Lever spring (1) with a screwdriver out of lug (2) on housing and
tilt upwards.
RA Removing and installing transmission (S5D 200G, M43TU)
BMW AG - TIS
19.01.2013 11:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
