3 Series E46 316i (M43TU) SAL
Install spacer (5).
Caution!
To avoid damaging input shaft, special tool 23 2 460 must
be inserted on the input shaft while installing the circlip (6).
Slide new circlip (6) over the special tool 23 2 460 and
install in the lower groove.
Install closing ring (4).
Caution!
To avoid damaging input shaft, special tool 23 2 460 must
be inserted on the input shaft while installing the circlip (3).
Slide new circlip (3) over the special tool 23 2 460 and
install in the upper groove.
Coat the radial seal sealing lip with ATF-oil. Push radial seal (1)
over special tool 23 2 460 up to case.
Remove special tool 23 2 460.
Drive in radial seal (1) with special tool 23 2 430.
Use plastic hammer to drive in.
RA Complete removal and installation of input and output shafts (S5D 200G/ 250G)
BMW AG - TIS
19.01.2013 11:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 11 -
