bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

ABOUT US
1 RA Replacing Radial Shaft Seal For Torque Converter (A5S 360R _ 390R, A4S 200R)|Page 1092 > < 1 RA Replacing Radial Shaft Seal For Torque Converter (A5S 360R _ 390R, A4S 200R)

3 Series E46 316i (M43TU) SAL

Page 2
background image

Screw special tool 24 4 000  into torque converter. 

Remove torque converter and set down vertically.

Replace sealing ring (1).

Release retaining screws (1) of radial shaft seal.

Pull radial shaft seal (1) out of converter housing with special
tool 00 5 010 .

Installation:

Coat sealing lips of radial shaft seal with automatic
transmission fluid.

Insert radial shaft seal. 

Tighten both retaining screws uniformly.

Tightening torque 24 11 2AZ .

RA  Replacing radial shaft seal for torque converter (A5S 360R / 390R, A4S 200R)

BMW AG - TIS

19.01.2013  11:58

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 2 -

1 RA Replacing Radial Shaft Seal For Torque Converter (A5S 360R _ 390R, A4S 200R)|Page 1092 > < 1 RA Replacing Radial Shaft Seal For Torque Converter (A5S 360R _ 390R, A4S 200R)