3 Series E46 316i (M43TU) SAL
Release screws.
Tightening torque, 26 11 1AZ.
Installation:
Replace self-locking nuts.
Grip propeller shaft and release nuts.
Tightening torque, 26 11 6AZ.
Bend propeller shaft downwards at center mount (1). Detach
propeller shaft from transmission output flange and tie back to
side on vehicle underbody.
Grip output flange (1) with special tool 23 0 020 .
Release hexagon nut.
Tightening torque, 24 21 1AZ.
Installation:
Replace inner sealing ring on output flange (1).
Install hexagon nut with screw retaining compound.
Remove spring washer (1).
Remove output flange (2).
Installation:
Note installation direction of spring washer (1).
RA Replacing radial seal for output flange (A4S 200R)
BMW AG - TIS
19.01.2013 11:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
