3 Series E46 316i (M43TU) SAL
32 31 102
Replacing steering spindle sleeve
Necessary preliminary tasks:
•
Remove underbody protective plate
•
Remove trim panel for pedal assembly.
•
Remove lower section of steering spindle
After installation:
•
Carry out steering angle sensor adjustment
Press crash disk (2) off crash sleeve (1).
Lift crash sleeve (1) out of groove of steering column and pull
down.
Installation:
Replace crash sleeve (1).
Push steering spindle upper section into steering column.
Remove holder for accelerator pedal.
Installation:
Tightening torque = 2.8 Nm.
RA Replacing steering spindle sleeve
BMW AG - TIS
19.01.2013 12:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
