3 Series E46 316i (M43TU) SAL
32 41 060
Removing and installing power steering vane
pump (M43)
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off pipe connections with plugs.
Necessary preliminary tasks:
•
Draw off and dispose off hydraulic fluid from fluid reservoir
Observe country-specific waste-disposal regulations
•
Remove underbody protective plate
•
Slacken drive belt and remove from belt pulley
Disconnect suction and pressure lines from vane pump.
Installation:
Replace sealing ring.
Tightening torque 32 41 3AZ
.
Remove pulley.
Unfasten screws.
Remove vane pump.
Tightening torque 32 41 1AZ
.
RA Removing and installing power steering vane pump (M43)
BMW AG - TIS
19.01.2013 12:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
