3 Series E46 316i (M43TU) SAL
34 00 025
Replacing fluid in ABS/ASC+T brake system
Note:
Read and comply with General Information.
Important!
When carrying out repairs to the brake system, follow the
procedure set out in Bleeding brake system.
Connect brake fluid changer to expansion tank and switch on.
Note:
Check relevant Operating Instructions for each device.
Charging pressure should not exceed 2 bar.
Flushing brake system completely
Connect bleeder hose with collecting tray to bleeder valve on rear
right brake caliper.
Open bleeder valve and purge until clear, bubble-free brake fluid
emerges.
Close bleed valve.
Follow same procedure on rear left, front right and front left wheel
brake.
RA Replacing fluid in ABS/ASC+T brake system
BMW AG - TIS
19.01.2013 13:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
