3 Series E46 316i (M43TU) SAL
34 31 500
Removing and installing / replacing the
master brake cylinder
Caution!
Note "General Data",
refer to 34 00 ...
After completing work, bleed brake system,
ABS/ASC+T, refer to 34 00 048.
ABS/DSC3, refer to 34 00 050.
Remove expansion tank,
refer to 34 31 181.
Unfasten brake lines (1/2).
1)
Circuit, front axle "V"
2)
Circuit, rear axle "H"
Release hexagon nuts (3) and remove master brake cylinder from
brake booster.
Installation:
Replace self-locking nuts.
Tightening Torque,
refer to Technical Data 34 31 1AZ.
Installation:
Do not tension flexible lines (1/2) between master brake
cylinder and hydraulic unit as this causes noises.
Installation:
Replace O-ring (1).
RA Removing and installing / replacing the master brake cylinder
BMW AG - TIS
19.01.2013 13:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
