3 Series E46 316i (M43TU) SAL
34 31 505
Removing and installing/replacing brake
master cylinder for DSC (MK60)
DSC (Dynamic Stability Control)
Note:
Read and comply with General Information.
After completing work:
Bleed brake system.
Remove expansion tank.
Remove pressure sensor "V" for DSC.
Remove pressure sensor "H" for DSC.
Detach brake lines (1).
Installation:
Tightening torque, 34 32 1AZ.
Unfasten hex nuts (2).
Withdraw brake master cylinder (3) from brake booster (4).
Installation:
Replace self-locking nuts.
Tightening torque, 34 31 1AZ.
Installation:
Replace sealing ring in O-shape (1).
Installation:
When inserting brake master cylinder (2) into brake booster
(1), make sure that pressure rod of brake booster (1) and
pressure rod of brake master cylinder (2) lie on a single plane.
RA Removing and installing/replacing brake master cylinder for DSC (MK60)
BMW AG - TIS
19.01.2013 13:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
