3 Series E46 316i (M43TU) SAL
34 33 505
Removing and installing/replacing brake
booster
Necessary preliminary tasks:
Remove brake master cylinder.
Remove ABS/ASC+T hydraulic unit.
Remove DSC3 precharging pump.
Remove brake pedal.
Note:
Read and comply with General Information.
After completing tasks, bleed brake system.
Release nuts (1).
Installation:
Replace self-locking nuts.
Tightening torque 34 33 12AZ
.
Carefully remove brake unit (1) from bulkhead and tilt out in
direction of engine.
Note:
Do not use any force when removing and installing the brake
unit; the brake unit can be damaged under certain
circumstances.
Remove brake unit vertically upwards out of equipment
compartment.
RA Removing and installing/replacing brake booster
BMW AG - TIS
19.01.2013 13:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
