3 Series E46 316i (M43TU) SAL
34 51 525
Removing and installing / replacing hydraulic
unit ABS/ASC+T
Note:
Follow general instructions,
refer to 34 00 ...
Before starting work, read out fault memory of ABS/ASC+T control
module and print out diagnostic record.
After completing work, carry out function test on ABS/ASC+T unit,
refer to BMW Diagnosis Information System (DIS).
After completing work, bleed brake system,
refer to 34 00 048.
Removing end firewall,
refer to 51 71 080.
Remove seal (1) towards top.
Remove vacuum line and B+line from assembly compartment
partition wall.
Turn seals (1) through 90
°
and thus unlock. Remove assembly
compartment partition wall (2) towards top.
Installation:
When installing the vacuum line and B+line, ensure rubber
grommets are correctly seated.
RA Removing and installing / replacing hydraulic unit ABS/ASC+T
BMW AG - TIS
19.01.2013 13:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
