3 Series E46 316i (M43TU) SAL
34 52 525
Removing and installing/replacing ABS front
pulse generator (MK60)
Open plug housing (1), pull plug connection (2) out of fixture and
disconnect.
Pull cable with rubber grommet out of fixture on spring strut and
on body.
Installation:
Make sure plug connection is properly engaged and rubber
grommet is correctly seated.
Release hexagon socket screw (1).
Withdraw ABS pulse generator (2) from bore hole.
Installation:
Tightening torque, 34 51 6AZ.
Installation:
There are different pulse generators for the MK60.
Pulse generators are marked "R" (right) and "L" (left).
Right pulse generator has two green markings between sensor
and grommet.
Installation:
Clean hole for pulse generator and grease with lubricating
grease Staburags NBU 12/K (refer to BMW Service Operating
Fluids).
RA Removing and installing/replacing ABS front pulse generator (MK60)
BMW AG - TIS
19.01.2013 13:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
