3 Series E46 316i (M43TU) SAL
Properties of cavity foam:
-
2K-PUR foam, solvent-free.
-
Excellent flow capacity, enabling complete sealing of cavities.
-
Good strength, preventing slipping in cavities.
-
Low water absorption, preventing corrosion.
Caution!
Observe processing instructions and safety precautions on
the spray can!
-
Use by date on can.
Do not use spray can after date marked on can, as then
the properties of the cavity foam no longer meet the
requirements of BMW AG.
-
Before application on the vehicle, it is advisable to fill a
well visible cavity of appropriate size with foam on an old
part.
This enables an optimal dosage (i.e. spraying time) to be
specified for filling the cavity on the vehicle with foam.
-
Substrate must be
clean and free from
dust,
grease,
oil and stripping agent.
Note:
If vapors are produced when the foam is removed, these
must be extracted. Ensure the area is well ventilated.
-
Application temperature: 20
°
C.
-
Tape off open passages to visible areas with adhesive
tape to prevent foam from escaping.
The foam can only be completely removed mechanically,
even when not completely hardened.
-
Application time after mixing: within 8 minutes.
-
Do not eat, drink or smoke during this operation.
-
Completely empty open can after use.
-
Cavity sealing of repair area is possible after a ventilation
time of 1 hour.
RA Installation of a cavity seal with cavity foam
BMW AG - TIS
19.01.2013 13:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
