3 Series E46 316i (M43TU) SAL
Make bulkhead carrier support partial replacement from bulkhead
carrier support spare part.
A = approx. 120 mm from edge of bulkhead carrier support
+ step dimension X
B = approx. 15 mm from bore
∅
7 mm +
step dimension X
Drill holes for plug welding.
Clean and coat joint surfaces with zinc dust paint.
Grind welded seam of engine support front section on mating
surface of bulkhead carrier support partial replacement.
Remove as little material as possible, do not grind thin!
Clean mating surfaces for bulkhead carrier support partial
replacement and coat with zinc dust paint.
Install bulkhead carrier support partial replacement, secure in
position and weld.
Grind all mating surfaces.
RA Replacing engine support front section on right
BMW AG - TIS
19.01.2013 14:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 11 -
