3 Series E46 316i (M43TU) SAL
Determine and mark inside B-pillar cutting line:
Measurement (A) = 50 mm from center of hole of upper seatbelt
height adjustment fixture.
Determine and mark cutting line for cover for front side member:
Measurement (A) = 150 mm from center of bore.
1 = 1st bore for finishing strip, entrance
1 = 2nd bore for finishing strip, entrance
Determine and mark cutting line for cover for rear side member:
Measurement (A) = 140 mm from center of bore for finishing
strip, entrance (1) with dia. 5.5 mm.
Measurement (B) = 140 mm from center of bore for panel for
cover on side member (2) with dia. 9.2 mm.
Caution!
Prior to cutting, support roof!
RA Replacing cover for side member, left or right (partial replacement, B-pillar be
BMW AG - TIS
19.01.2013 14:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
