3 Series E46 316i (M43TU) SAL
Grind welding spots until they are smooth.
Cut inside B-pillar spare part.
Measurement (A) = 50 mm from centre of hole of upper seatbelt
height adjustment fixture.
Fit inside B-pillar spare part.
Gap between seatbelt height adjustment fixtures (A) = 173 mm.
To fit, install seatbelt height adjustment fixture.
Mark holes for plug welding of
reinforcement plate, inside B-pillar and
inside B-pillar spare part on cover for side member.
Make reinforcement plate from surplus sheet metal.
Reinforcement plate width = approx. 40 mm
RA Replacing cover for side member, left or right (partial replacement, B-pillar be
BMW AG - TIS
19.01.2013 14:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 14 -
