3 Series E46 316i (M43TU) SAL
Fitting shaped part for cavity sealing on cars with slide/tilt
sunroofs:
Clean shaped part for cavity bulkhead.
Shaped part for cavity bulkhead (1) is behind water drainage pipe
for sunroof (2).
Fit shaped part for cavity sealing (1) on body.
Apply window adhesive approx. 20 mm high to shaped part for
cavity sealing and to sunroof water drainage pipe.
Install side panel reinforcement spare part and locate in position.
Note:
During installation, make sure the clips are passed through
the bores provided.
Pull clips with pliers through bores until they are locked.
The clips serve to secure the shaped part for the cavity sealing to
the side panel reinforcement.
Fitting shaped part for cavity sealing on cars without slide/tilt
sunroofs:
RA Replacing outer section of left or right rear wheel housing (side panel removed)
BMW AG - TIS
19.01.2013 14:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 12 -
