3 Series E46 316i (M43TU) SAL
Caution!
Observe safety instructions when dealing with
-
activator for original BMW windshield adhesive, refer to
BMW Parts Service
-
original BMW windshield adhesive, refer to BMW Parts
Service
.
Shaped parts with clips:
Caution!
If clips are fitted to shaped parts to secure them, do not allow
clips to engage.
Fit shaped part and mark up contact face on body and spare
part, fitting spare part if necessary.
Shaped parts with bore for retaining tabs:
Fit shaped part and allow retaining tabs to locate in bores.
Mark up contact face on body and spare part, fitting spare part if
necessary.
If necessary, remove spare part once again.
Remove shaped part.
Surface-sand flanging surfaces of shaped part with coarse
sandpaper (50 - 100 grain).
Clean contact surfaces on the body and on the shaped part with
activator for original BMW windshield adhesive.
RA Installing shaped parts for cavity bulkheads, except for cover for side member
BMW AG - TIS
19.01.2013 14:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
