3 Series E46 316i (M43TU) SAL
Heat foam area and remove cowl panel.
Measurement (A) = 300 mm from roof edge.
Position of foam parts,
refer to 41 00 ... Arrangement of shaped parts for cavity bulkhead
Straighten and grind joint surfaces.
Remove foam residue (1) from cavity bulkhead.
Mark out and cut partition areas (top/bottom) on cowl panel spare
part.
Make reinforcement plate from remaining metal sheet for
connection, top.
Width approx. 40 mm.
RA Replacing left or right cowl panel (partial replacement in front of roof connect
BMW AG - TIS
19.01.2013 14:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
